Categories Decks

Platform Steps For A Deck

Posted on

Platform Steps For A Deck

Most deck builders use 2×6 material to frame the stair boxes and use (2) 5/4×6 deck boards for each tread with a 1/2" overhang over the riser board. Cut the sides of the boxes and fill in the interior with blocking every 16" on center for wood decks and 12" on center for composite decks.
Image result for diy platform steps #buildingadeck Building Deck Steps, How To Build. Patio Steps, House Deck, Building A Deck, Front Stairs, Deck Stairs,.
Cut five pieces of framing, three pieces 3 inches shorter than the width of your stair tread. Cut two pieces as wide as your stair tread from 2×8 PT material. Stand the front and back pieces on edge and position the three shorter pieces between them, perpendicular to the front and rear pieces to create a rectangle.
Follow the steps below to build your own deck stairs. Step 1: Measure, Calculate and Mark. Before you seek to do anything with the steps, get one of the wooden boards to mark your measurements. Step 2: Decide the Deck Step Design. Step 3: Place the Wooden Planks. Step 4: Nailing the Step Planks.
Decks are a relatively inexpensive way of extending houses and access to their entrance is usually made if you build deck steps. Box steps made on private .
Box steps are fully covered stairs that lead you up to the deck surface. If you're building them at your home, you can customize them: you can place them around .
Most decks require only one or two steps to lead from the ground floor level of a. open tops of the steps with the same decking used on the main deck platform.
The final part of the deck build is the stairs. Building stairs takes some math and a little know-how. Follow these steps for a safe set of wood deck stairs.

Gallery of Platform Steps For A Deck

More from my site

Leave a Comment

This site uses Akismet to reduce spam. Learn how your comment data is processed.